-
Misaligned Line in PDF Report
Hello everyone,
I hope you’re all doing well. I’m reaching out for some guidance regarding an issue I encountered with a report in our system.
When designing a report with boundary lines in the report design tool, there is a discrepancy between the design view and the runtime view (PDF generation). The lines are properly aligned in the design view, but in the generated PDF, the line appears misaligned or incorrectly sized.
The following image shows the report in design mode, where the line is positioned correctly:(original)
I am using the latest version of Omnis Studio, and I am working with remote forms.
-
This discussion was modified 2 years ago by
Rafael Garcia Casilla.
-
This discussion was modified 2 years ago by
-
2 Replies
-
Hello Rafael,
This looks like a known fault: ST/EC/1888 – Printing to PDF seems to extend lines further than expected
I would suggest that you contact your local Omnis office as the fault should be fixed in the latest Omnis Studio Now build.
Götz
-
Hello Götz Krija, thank you very much for the information. I have already contacted them.
-
Log in to reply.